The CRK42 Reflector Kit
and RBH2566 Mounting Arm
The
5-in-1 Circular Reflector Kit offers you the versatility of five different
reflector panels for unique lighting effects, in a simple, combined set. The fabric panels zip and unzip to quickly
change the panel being used.
The Gold
Bounce Panel provides a warm glow, excellent for portrait work, offering
gorgeous skin tones.
The Silver
Bounce Panel provides a highly reflective, high output bounce,
increasing highlights.
The White
Bounce Panel creates a very natural bounced light source, with a bright
output.
The Black
Absorption Panel is designed to absorb any light that it receives, and not
allow any reflection. This panel is ideal for catching ambient light, sunlight,
or window light in your shoot, minimizing unattractive hot spots.
The
Translucent White Diffusion Panel diffuses light to minimize shadows and
soften a light’s output.
Each
circular panel measures 42 inches in diameter.
The translucent white panel can stand alone, or serve as the frame for
the reversible panels that zip around it (with the black and gold sides out or
the white and silver sides out).
The
mounting bracket tightens and loosens when the side handles are twisted. You will first twist one side to loosen the
bracket, and fit it on the second section of your light stand. You will then twist the opposite side to hold
the silver arm. The bracket is designed
to fit around multiple pole sizes, having three holes. You will need to twist the bracket until you
find the appropriate sizes for the RBH2566 silver arm and your light stand.
1.
Twist the handle until it comes off of the mounting piece, revealing a silver
washer around the inside screw. Remove
the silver washer.
2.
Pull one side of the bracket off of the center screw. The light stand pole fits between the two
sides. Position the bracket around the
pole of the light stand, and allow the pole to fit in the remaining groove.
3.
Slide the removed side back on to the center screw, with the pole of the light
stand nestled snugly between.
4.
Once together, replace the silver washer, and screw the handle back on the
mounting bracket until it is secure.
5.
Twist and remove the handle on the other side, again removing the washer and
pulling one side of the bracket off of the screw. The silver holding arm fits between the two
sides, in the remaining groove.
6.
Slide the removed side back on to the center screw, with the silver arm nestled
snugly between. Once together, replace the washer, and screw the handle back on
the mounting bracket until it is secure.
7.
On each end of the silver holding arm, there is a small black clip which
attaches to the rim of your round reflector panel on both sides. The spring on the clip is very tight, and the
clip is pulled back to open, then released to snap closed. The silver holding arm can be adjusted from
25 to 66 inches for various placement and holding capabilities.
The
Reflector Kit bends and twists to fold into a small circle, fitting inside the
provided carrying bag. The carrying bag
zips along the outside to fit the kit, folded down to a 16-inch diameter
circle.
White Lightning, a
division of Paul C. Buff, Inc.
2725 Bransford Avenue Nashville, TN
37204
Toll Free 1-800-443-5542
Local (615) 383-3982
Fax (615) 383-0676